Fully Portable & Easy Setup: Very easy to setup, take down and store. A little muscle is needed to put the ground anchor kit into the ground if you're setting up in hard soil.
Perfect Height for Beginners: The Slackabout stands position the slackline about 2 feet (23.5 inches) off the ground... an easy height for getting on and off the line.
How it Works: The Slackabouts work best with low ground anchor points. In urban areas this could be lamp posts, sewer grates, etc. Really any "solid" point that can hold the line. You can also set up in grassy areas using the included ground anchor kit (see instructional video / instructions also included).
Total weight of a-frames and augers: 13lbs
Standing height of a-frames set up: 23.5"
Q: Is there a weight limit? A: The weight the system will support depends on the solidity of the anchoring endpoints. The maximum recommended weight for our slacklines is 300lbs. The Slackabout stands themselves can also support that much weight. The ground anchors, however, can only hold so much weight before they pull out of the ground. The amount of weight they can hold depends on a couple of key factors: (1) how far apart you've spaced the Slackabout stands; (2) the angle at which you've drilled in the augers; and (3) the type of soil of the ground. In general, our recommendations to ensure the augers don't pull out are:
Space the stands 25ft apart for adults, and 30 - 35ft apart for children.
Angle in the anchor kit at 45-degrees toward the stands when putting them in the ground (vs going straight down).
Q: What are good anchor points to use in a gym? A: We favor solid metal weight racks that are bolted into the ground.
Q: What's the most efficient way to put the anchor kit into the ground? A: Depending on the ground, body weight should work. In more difficult ground, a rubber mallet or a hammer+scrap wood (2x4) will work. Keep in mind softer ground is best for temporary setup. The harder it is to install in the ground, the more difficult it may be to remove.
Setup Instructions (in grass using ground anchor kit)
Anchor according to video instructions.
Ratchet the slackline down until there is just a little bit of slack in the line.
Place the a-frames under the line about 5ft from each anchor point. Raise up the a-frames so that the pressure of the line keeps them in place. If you can't raise them up, the line is too tight.
Tighten down ratchet to desired tension. Tension should be enough to keep the feet of the slackline walker off the ground in the middle.